Description
discontinued – see our complete replacement Gecko control systems with wifi support.
Vita Spa Side L500 and LC500 as found in 1998 to 2001 spa models.
This is the Selectron Vita Spa 8 button control panel that includes the overlay.
VIT460087 or 460087 control panel buttons include:
Upper Row: Temp Up Low/High Bubbles Light
Bottom Row: Temp Down View Mode Program
Back of control panel is flat – about 4 inches tall.
Get your original replacement Vita spa replacement control panels at Hot Tub Outpost.
Vita Spa control panel VIT460087 settings.
G. FREEZE PROTECTIONIf the temperature in the spa plumbing falls below 50º Fahrenheit (10º Celsius) the water pump(s) will turn on soft-mode and run for at least one minute. The display will show . After one minute, if the water is still below 50º F (10º Celsius), the heater will turn on and raise the water temperature 10º F.
H. FLOW PROTECTIONIf the flow of water through the heater is insufficient, the spa controller will automatically turn the heater off to prevent overheating. The display will show , indicating a flow restriction caused by a clogged filter, shut gate valves or by a malfunction in the pressure switch. Call for service if you cannot pinpoint the cause.I. OVERHEAT PROTECTIONIf the water temperature inside the spa reaches 110º F, the display will show (High Limit) and the heater will be disabled. If the water temperature continues to rise and reaches 118º F due to friction in the pumps and plumbing system, the entire system including all pumps will be disabled. In condition, Remove the cover and allow the water temperature to cool down to 104 degrees F. Then reset the system by holding down the button for 5 seconds.If the message returns, call for service. K. H.E.E.T PUMPEach spa is equipped with Vita Spa’s exclusive pump. Similar to the principle of heat transfer pumps, the system ransfers the heat generated by the circulation pump motor to the water 24 hours a day. After the first twelve hours of operation each day, as a protection against overheating, the . pump will turn off if the water temperature exceeds thedesired temperature. The 4kw-system heater will come back on when the water temperature falls 1 degree F° under the desired temperature.L. SKIM-AWAYSkim – Away is an automatic skimming action which takes place each day from 8am until 8:30am each morning and from 4pm until 4:30pm each afternoon. The primary pump will activate in high speed mode. This will pull all surface oils and debris into the filter well cavity.M. REMOTE CONTROLYour spa model may come equipped with a remote control located on the opposite side of the spa from the main spa side control.The remote control will operate the jets, blower, and light. It can not be used to program the spa.
Plug Type
Phone style plug type.
Factory original replacement part includes overlay.
