Description

The DEWALT ACCESSORIES DD5118 is a 9/32-inch titanium impact drill bit sold in a 3-pack, engineered for use in 1/4-inch hex shank impact drivers. A Titanium Nitride coating increases surface hardness and extends service life compared to standard high-speed steel bits. The patented web taper stiffens the bit body to reduce breakage risk under the high-torque loads typical of impact drivers. The patented Pilot Point tip starts on contact without walking, and optimized flute geometry pulls chips out of the hole quickly for cleaner, faster drilling across a range of materials.

These bits are designed for drilling in metal, wood, and plastic. The 1/4-inch hex shank seats directly into any standard impact driver quick-change chuck, making them a practical addition to any service truck or job-site bag. The 9/32-inch diameter is commonly used for bolt clearance holes, anchor pilot holes, and general fabrication tasks. Sold as a 3-pack, they are suited for tradespeople who run through bits regularly and need consistent replacements on hand.

Key Features

Titanium Nitride coating increases hardness and extends bit life over standard steel bits
Patented Pilot Point tip eliminates bit walking for accurate, clean hole starts
Patented web taper adds rigidity along the bit body to resist breakage under impact-driver torque
Optimized flute geometry promotes fast chip extraction and cooler cutting temperatures
1/4-inch hex shank is compatible with all standard impact driver quick-change chucks
3-pack quantity supports high-use field applications

Compatibility

Designed for use in 1/4-inch hex shank impact drivers. Suitable for drilling into metal, wood, and plastic.

Installation Notes

Seat the hex shank fully into the impact driver chuck before operating. Confirm the chuck is locked before drilling. Apply steady, moderate pressure excessive force on small-diameter bits accelerates wear and increases breakage risk. When drilling metal, use an appropriate cutting fluid to reduce heat buildup and extend bit life.