Description

The CONTINENTAL CONTITECH 20039608 is a BX-section cogged V-belt designed for power transmission applications in HVAC, industrial, and mechanical drive systems. Built with fiber-reinforced Vytracord construction, this belt delivers consistent torque transfer under demanding load conditions. The cogged profile reduces bending resistance and heat buildup, improving efficiency across variable-speed and high-torque drive configurations. It carries an outside length of 98.0 inches and an internal length of 96.80 inches. Licensed HVAC technicians and mechanical service professionals handle installation in blower, fan, and compressor drive setups.

This belt is suited for residential and light commercial HVAC systems, as well as general industrial drive applications where a BX-section cogged belt is specified. The Torque-Flex style designation indicates suitability for drives with smaller sheave diameters where a standard wrapped belt would suffer excessive flexing stress. Oil-resistant construction makes it appropriate for environments where incidental fluid contact is a concern. Rated for operating temperatures from -40 degrees C to 60 degrees C, it performs reliably across a wide service range.

Key Features

BX-section cogged profile reduces flex resistance and heat generation on small-diameter sheaves
Fiber-reinforced Vytracord construction for stable torque transmission under load
Oil-resistant material suitable for environments with incidental fluid exposure
Operating temperature range: -40 degrees C to 60 degrees C
Outside length of 98.0 inches with internal length of 96.80 inches
Torque-Flex style for compatibility with drives requiring flexible belt engagement

Compatibility

Designed as a BX95 replacement cogged V-belt for drives specifying a BX-section belt with a 98.0-inch outside length. Verify sheave groove profile and center distance before installation.

Installation Notes

Installation should be performed by a qualified technician. Disconnect and lock out power to the drive system before removing or installing the belt. Never pry a belt onto a sheave with a screwdriver or bar; adjust center distance to allow proper belt seating. After installation, check belt tension and sheave alignment according to drive system manufacturer specifications before returning the unit to service.