Description

The B K/MUELLER INDS(IMPORT) 510-508HC is a 2-inch galvanized street elbow configured at a 45-degree angle, used to redirect pipe runs in threaded iron piping systems. The street configuration features one male-threaded end and one female-threaded end, allowing direct connection without a separate coupling. The galvanized finish provides corrosion resistance for use in water supply, gas distribution, and general plumbing applications. Licensed plumbers and pipefitters install this fitting as a standard component in residential and light commercial pipe assemblies.

This 45-degree street elbow is suited for residential and commercial threaded iron piping systems where a moderate directional change is required without adding extra fittings. It is commonly installed in water supply lines, drainage venting configurations, and low-pressure gas piping where threaded galvanized iron pipe is the specified material. The 2-inch nominal pipe size fits standard Schedule 40 threaded iron pipe of the same diameter. Packages contain 8 units per quantity, making this SKU appropriate for contractors stocking multiple fittings per job.

Key Features

45-degree angle provides a gradual directional change in threaded pipe runs
Street configuration with one male and one female threaded end eliminates need for an extra coupling
Galvanized finish resists corrosion in wet and humid installation environments
2-inch nominal size fits standard Schedule 40 threaded galvanized iron pipe
Sold in packages of 8 units for efficient contractor stocking

Compatibility

Designed as an OEM-style replacement fitting for 2-inch nominal threaded galvanized iron piping systems in residential and commercial plumbing applications.

Installation Notes

Installation should be performed by a licensed plumber in accordance with applicable local plumbing codes and IPC requirements. Shut off and depressurize the pipe system fully before cutting into any existing line. Apply an approved thread sealant or PTFE tape to all male threads before making up connections. Do not over-tighten threaded fittings, as this can crack the fitting body or damage threads.