Description

The PELCO INC. ECPS-48VDC-5A is a 48-volt DC, 5-amp power supply designed to support 4-channel Power over Ethernet (PoE) access point applications. It delivers stable DC power to PoE-enabled network equipment, making it a purpose-built supply for installations where consistent voltage and sufficient current capacity are critical. Security integrators, network technicians, and low-voltage electricians install this unit as part of structured cabling and surveillance or access control systems. The 48-volt output matches standard PoE voltage requirements, and the 5-amp rating provides enough current headroom for multi-port PoE distribution in small to mid-scale deployments.

This power supply is suited for use with 4-channel PoE access point equipment in commercial and light-industrial environments. Typical installation scenarios include IP camera systems, wireless access point infrastructure, and access control panels that rely on PoE for device power. It is sold as a single unit and is appropriate for new installations as well as replacement of failed power supplies in existing PoE distribution setups.

Key Features

48-volt DC output matched to standard PoE equipment requirements
5-amp current capacity supports 4-channel PoE access point loads
Purpose-built for powerline Ethernet and PoE access point applications
Single-unit packaging for straightforward deployment or direct replacement

Compatibility

Designed as a replacement or supplemental power supply for 4-channel PoE access point systems requiring a 48-volt DC, 5-amp power source. Consult equipment documentation to confirm voltage and current requirements before installation.

Installation Notes

Installation should be performed by a licensed low-voltage technician or electrician familiar with PoE power distribution systems. De-energize all connected equipment before disconnecting or replacing the power supply. Verify that the load current of all connected PoE ports does not exceed the 5-amp output rating of this unit. Local codes, including applicable NEC low-voltage provisions, should be observed during installation.