Description

The CHARLOTTE PIPE FOUNDRY CO. ABS 00428 0600HA is a 1-1/2 inch ABS DWV double sanitary tee configured in a hub x hub x hub arrangement. This fitting connects a branch drain line into a vertical drain stack in non-pressure drain, waste, and vent systems. Molded from black ABS material, it is designed for residential and light commercial DWV applications where a dual-inlet tee connection is required. Licensed plumbers install this fitting as part of rough-in drain work. Note that ABS material carries low chemical resistance, which should be evaluated against the specific waste stream before installation.

This double sanitary tee is suited for non-pressure DWV piping systems in residential new construction and remodel projects. It is used where two branch lines must connect into a single vertical drain stack at the same elevation. The hub x hub x hub configuration accepts standard ABS pipe with solvent-cement joints on all three openings. It is not intended for pressurized supply lines or outdoor UV-exposed installations without additional protection.

Key Features

Double sanitary tee allows two branch lines to tie into a vertical drain stack
Hub x hub x hub configuration on all three ports for solvent-cement joints
1-1/2 inch size for standard DWV branch and stack connections
Black ABS material for non-pressure drain, waste, and vent service
Low chemical resistance rating verify suitability for specific waste stream
Sold in a package quantity of 25 units per carton

Compatibility

Designed as an OEM-style DWV fitting compatible with standard 1-1/2 inch ABS pipe in non-pressure drain, waste, and vent installations.

Installation Notes

Installation should be performed by a licensed plumber in accordance with the International Plumbing Code (IPC) or applicable local codes. Shut off water supply and ensure the drain system is depressurized before cutting into an existing stack. Use ABS-rated solvent cement and primer appropriate for the pipe material; follow manufacturer cure times before restoring flow. This fitting is for DWV use only and must not be installed in pressurized supply lines.